Spracherkennung für: .dts vermutete Sprache: Unknown {[0] [0] [0]} [Methode: Schwerpunktbildung, einfache Gewichte, sechs Dimensionen]
// SPDX-License-Identifier: GPL-2.0
/dts-v1/;
/ {
model = "ARM Versatile AB";
compatible = "arm,versatile-ab";
#address-cells = <1>;
#size-cells = <1>;
interrupt-parent = <&vic>;
aliases {
serial0 = &uart0;
serial1 = &uart1;
serial2 = &uart2;
i2c0 = &i2c0;
};
chosen {
stdout-path = &uart0;
};
memory {
device_type = "memory";
reg = <0x0 0x08000000>;
};
xtal24mhz: clock-24000000 {
#clock-cells = <0>;
compatible = "fixed-clock";
clock-frequency = <24000000>;
};
bridge {
compatible = "ti,ths8134b", "ti,ths8134";
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
vga_bridge_in: endpoint {
remote-endpoint = <&clcd_pads_vga_dac>;
};
};
port@1 {
reg = <1>;
vga_bridge_out: endpoint {
remote-endpoint = <&vga_con_in>;
};
};
};
};
vga {
compatible = "vga-connector";
label = "J1";
port {
vga_con_in: endpoint {
remote-endpoint = <&vga_bridge_out>;
};
};
};
core-module@10000000 {
compatible = "arm,core-module-versatile", "syscon", "simple-mfd";
reg = <0x10000000 0x200>;
ranges = <0x0 0x10000000 0x200>;
#address-cells = <1>;
#size-cells = <1>;
led@8,0 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x01>;
label = "versatile:0";
linux,default-trigger = "heartbeat";
default-state = "on";
};
led@8,1 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x02>;
label = "versatile:1";
linux,default-trigger = "mmc0";
default-state = "off";
};
led@8,2 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x04>;
label = "versatile:2";
linux,default-trigger = "cpu0";
default-state = "off";
};
led@8,3 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x08>;
label = "versatile:3";
default-state = "off";
};
led@8,4 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x10>;
label = "versatile:4";
default-state = "off";
};
led@8,5 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x20>;
label = "versatile:5";
default-state = "off";
};
led@8,6 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x40>;
label = "versatile:6";
default-state = "off";
};
led@8,7 {
compatible = "register-bit-led";
reg = <0x08 0x04>;
offset = <0x08>;
mask = <0x80>;
label = "versatile:7";
default-state = "off";
};
/* OSC1 on AB, OSC4 on PB */
osc1: clock-osc {
#clock-cells = <0>;
compatible = "arm,versatile-cm-auxosc";
clocks = <&xtal24mhz>;
};
/* The timer clock is the 24 MHz oscillator divided to 1MHz */
timclk: clock-1000000 {
#clock-cells = <0>;
compatible = "fixed-factor-clock";
clock-div = <24>;
clock-mult = <1>;
clocks = <&xtal24mhz>;
};
pclk: clock-pclk {
#clock-cells = <0>;
compatible = "fixed-factor-clock";
clock-div = <1>;
clock-mult = <1>;
clocks = <&xtal24mhz>;
};
};
flash@34000000 {
/* 64 MiB NOR flash in non-interleaved chips */
compatible = "arm,versatile-flash", "cfi-flash";
reg = <0x34000000 0x04000000>;
bank-width = <4>;
partitions {
compatible = "arm,arm-firmware-suite";
};
};
i2c0: i2c@10002000 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "arm,versatile-i2c";
reg = <0x10002000 0x1000>;
rtc@68 {
compatible = "dallas,ds1338";
reg = <0x68>;
};
};
net@10010000 {
compatible = "smsc,lan91c111";
reg = <0x10010000 0x10000>;
interrupts = <25>;
};
lcd@10008000 {
compatible = "arm,versatile-lcd";
reg = <0x10008000 0x1000>;
};
amba {
compatible = "simple-bus";
#address-cells = <1>;
#size-cells = <1>;
ranges;
vic: interrupt-controller@10140000 {
compatible = "arm,versatile-vic";
interrupt-controller;
#interrupt-cells = <1>;
reg = <0x10140000 0x1000>;
valid-mask = <0xffffffff>;
};
sic: interrupt-controller@10003000 {
compatible = "arm,versatile-sic";
interrupt-controller;
#interrupt-cells = <1>;
reg = <0x10003000 0x1000>;
interrupt-parent = <&vic>;
interrupts = <31>; /* Cascaded to vic */
clear-mask = <0xffffffff>;
/*
* Valid interrupt lines mask according to
* table 4-36 page 4-50 of ARM DUI 0225D
*/
valid-mask = <0x0760031b>;
};
dma@10130000 {
compatible = "arm,pl081", "arm,primecell";
reg = <0x10130000 0x1000>;
interrupts = <17>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
uart0: serial@101f1000 {
compatible = "arm,pl011", "arm,primecell";
reg = <0x101f1000 0x1000>;
interrupts = <12>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "uartclk", "apb_pclk";
};
uart1: serial@101f2000 {
compatible = "arm,pl011", "arm,primecell";
reg = <0x101f2000 0x1000>;
interrupts = <13>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "uartclk", "apb_pclk";
};
uart2: serial@101f3000 {
compatible = "arm,pl011", "arm,primecell";
reg = <0x101f3000 0x1000>;
interrupts = <14>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "uartclk", "apb_pclk";
};
smc@10100000 {
compatible = "arm,primecell";
reg = <0x10100000 0x1000>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
mpmc@10110000 {
compatible = "arm,primecell";
reg = <0x10110000 0x1000>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
display@10120000 {
compatible = "arm,pl110", "arm,primecell";
reg = <0x10120000 0x1000>;
interrupts = <16>;
clocks = <&osc1>, <&pclk>;
clock-names = "clcdclk", "apb_pclk";
/* 800x600 16bpp @ 36MHz works fine */
max-memory-bandwidth = <54000000>;
/*
* This port is routed through a PLD (Programmable
* Logic Device) that routes the output from the CLCD
* (after transformations) to the VGA DAC and also an
* external panel connector. The PLD is essential for
* supporting RGB565/BGR565.
*
* The signals from the port thus reaches two endpoints.
* The PLD is managed through a few special bits in the
* FPGA "sysreg".
*
* This arrangement can be clearly seen in
* ARM DUI 0225D, page 3-41, figure 3-19.
*/
port@0 {
#address-cells = <1>;
#size-cells = <0>;
clcd_pads_panel: endpoint@0 {
reg = <0>;
remote-endpoint = <&panel_in>;
arm,pl11x,tft-r0g0b0-pads = <0 8 16>;
};
clcd_pads_vga_dac: endpoint@1 {
reg = <1>;
remote-endpoint = <&vga_bridge_in>;
arm,pl11x,tft-r0g0b0-pads = <0 8 16>;
};
};
};
sctl@101e0000 {
compatible = "arm,primecell";
reg = <0x101e0000 0x1000>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
watchdog@101e1000 {
compatible = "arm,primecell";
reg = <0x101e1000 0x1000>;
interrupts = <0>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
timer@101e2000 {
compatible = "arm,sp804", "arm,primecell";
reg = <0x101e2000 0x1000>;
interrupts = <4>;
clocks = <&timclk>, <&timclk>, <&pclk>;
clock-names = "timer0", "timer1", "apb_pclk";
};
timer@101e3000 {
compatible = "arm,sp804", "arm,primecell";
reg = <0x101e3000 0x1000>;
interrupts = <5>;
clocks = <&timclk>, <&timclk>, <&pclk>;
clock-names = "timer0", "timer1", "apb_pclk";
};
gpio0: gpio@101e4000 {
compatible = "arm,pl061", "arm,primecell";
reg = <0x101e4000 0x1000>;
gpio-controller;
interrupts = <6>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
gpio1: gpio@101e5000 {
compatible = "arm,pl061", "arm,primecell";
reg = <0x101e5000 0x1000>;
interrupts = <7>;
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
rtc@101e8000 {
compatible = "arm,pl030", "arm,primecell";
reg = <0x101e8000 0x1000>;
interrupts = <10>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
sci@101f0000 {
compatible = "arm,primecell";
reg = <0x101f0000 0x1000>;
interrupts = <15>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
spi@101f4000 {
compatible = "arm,pl022", "arm,primecell";
reg = <0x101f4000 0x1000>;
interrupts = <11>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "sspclk", "apb_pclk";
};
fpga {
compatible = "arm,versatile-fpga", "simple-bus";
#address-cells = <1>;
#size-cells = <1>;
ranges = <0 0x10000000 0x10000>;
sysreg@0 {
compatible = "arm,versatile-sysreg", "syscon", "simple-mfd";
reg = <0x00000 0x1000>;
panel: display@0 {
compatible = "arm,versatile-tft-panel";
port {
panel_in: endpoint {
remote-endpoint = <&clcd_pads_panel>;
};
};
};
};
aaci@4000 {
compatible = "arm,primecell";
reg = <0x4000 0x1000>;
interrupts = <24>;
clocks = <&pclk>;
clock-names = "apb_pclk";
};
mmc@5000 {
compatible = "arm,pl180", "arm,primecell";
reg = <0x5000 0x1000>;
interrupts-extended = <&vic 22 &sic 1>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "mclk", "apb_pclk";
};
kmi@6000 {
compatible = "arm,pl050", "arm,primecell";
reg = <0x6000 0x1000>;
interrupt-parent = <&sic>;
interrupts = <3>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "KMIREFCLK", "apb_pclk";
};
kmi@7000 {
compatible = "arm,pl050", "arm,primecell";
reg = <0x7000 0x1000>;
interrupt-parent = <&sic>;
interrupts = <4>;
clocks = <&xtal24mhz>, <&pclk>;
clock-names = "KMIREFCLK", "apb_pclk";
};
};
};
};
