Quellcodebibliothek Statistik Leitseite products/Sources/formale Sprachen/C/Linux/drivers/hwspinlock/   (Open Source Betriebssystem Version 6.17.9©)  Datei vom 24.10.2025 mit Größe 4 kB image not shown  

Quelle  omap_hwspinlock.c   Sprache: C

 
// SPDX-License-Identifier: GPL-2.0
/*
 * OMAP hardware spinlock driver
 *
 * Copyright (C) 2010-2021 Texas Instruments Incorporated - https://www.ti.com
 *
 * Contact: Simon Que <sque@ti.com>
 *          Hari Kanigeri <h-kanigeri2@ti.com>
 *          Ohad Ben-Cohen <ohad@wizery.com>
 *          Suman Anna <s-anna@ti.com>
 */


#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/device.h>
#include <linux/delay.h>
#include <linux/io.h>
#include <linux/bitops.h>
#include <linux/pm_runtime.h>
#include <linux/slab.h>
#include <linux/spinlock.h>
#include <linux/hwspinlock.h>
#include <linux/of.h>
#include <linux/platform_device.h>

#include "hwspinlock_internal.h"

/* Spinlock register offsets */
#define SYSSTATUS_OFFSET  0x0014
#define LOCK_BASE_OFFSET  0x0800

#define SPINLOCK_NUMLOCKS_BIT_OFFSET (24)

/* Possible values of SPINLOCK_LOCK_REG */
#define SPINLOCK_NOTTAKEN  (0) /* free */
#define SPINLOCK_TAKEN   (1) /* locked */

static int omap_hwspinlock_trylock(struct hwspinlock *lock)
{
 void __iomem *lock_addr = lock->priv;

 /* attempt to acquire the lock by reading its value */
 return (SPINLOCK_NOTTAKEN == readl(lock_addr));
}

static void omap_hwspinlock_unlock(struct hwspinlock *lock)
{
 void __iomem *lock_addr = lock->priv;

 /* release the lock by writing 0 to it */
 writel(SPINLOCK_NOTTAKEN, lock_addr);
}

/*
 * relax the OMAP interconnect while spinning on it.
 *
 * The specs recommended that the retry delay time will be
 * just over half of the time that a requester would be
 * expected to hold the lock.
 *
 * The number below is taken from an hardware specs example,
 * obviously it is somewhat arbitrary.
 */

static void omap_hwspinlock_relax(struct hwspinlock *lock)
{
 ndelay(50);
}

static const struct hwspinlock_ops omap_hwspinlock_ops = {
 .trylock = omap_hwspinlock_trylock,
 .unlock = omap_hwspinlock_unlock,
 .relax = omap_hwspinlock_relax,
};

static int omap_hwspinlock_probe(struct platform_device *pdev)
{
 struct hwspinlock_device *bank;
 void __iomem *io_base;
 int num_locks, i, ret;
 /* Only a single hwspinlock block device is supported */
 int base_id = 0;

 io_base = devm_platform_ioremap_resource(pdev, 0);
 if (IS_ERR(io_base))
  return PTR_ERR(io_base);

 /*
 * make sure the module is enabled and clocked before reading
 * the module SYSSTATUS register
 */

 devm_pm_runtime_enable(&pdev->dev);
 ret = pm_runtime_resume_and_get(&pdev->dev);
 if (ret < 0)
  return ret;

 /* Determine number of locks */
 i = readl(io_base + SYSSTATUS_OFFSET);
 i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET;

 /*
 * runtime PM will make sure the clock of this module is
 * enabled again iff at least one lock is requested
 */

 ret = pm_runtime_put(&pdev->dev);
 if (ret < 0)
  return ret;

 /* one of the four lsb's must be set, and nothing else */
 if (hweight_long(i & 0xf) != 1 || i > 8)
  return -EINVAL;

 num_locks = i * 32; /* actual number of locks in this device */

 bank = devm_kzalloc(&pdev->dev, struct_size(bank, lock, num_locks),
       GFP_KERNEL);
 if (!bank)
  return -ENOMEM;

 for (i = 0; i < num_locks; i++)
  bank->lock[i].priv = io_base + LOCK_BASE_OFFSET + sizeof(u32) * i;

 return devm_hwspin_lock_register(&pdev->dev, bank, &omap_hwspinlock_ops,
      base_id, num_locks);
}

static const struct of_device_id omap_hwspinlock_of_match[] = {
 { .compatible = "ti,omap4-hwspinlock", },
 { .compatible = "ti,am64-hwspinlock", },
 { .compatible = "ti,am654-hwspinlock", },
 { /* end */ },
};
MODULE_DEVICE_TABLE(of, omap_hwspinlock_of_match);

static struct platform_driver omap_hwspinlock_driver = {
 .probe  = omap_hwspinlock_probe,
 .driver  = {
  .name = "omap_hwspinlock",
  .of_match_table = omap_hwspinlock_of_match,
 },
};

static int __init omap_hwspinlock_init(void)
{
 return platform_driver_register(&omap_hwspinlock_driver);
}
/* board init code might need to reserve hwspinlocks for predefined purposes */
postcore_initcall(omap_hwspinlock_init);

static void __exit omap_hwspinlock_exit(void)
{
 platform_driver_unregister(&omap_hwspinlock_driver);
}
module_exit(omap_hwspinlock_exit);

MODULE_LICENSE("GPL v2");
MODULE_DESCRIPTION("Hardware spinlock driver for OMAP");
MODULE_AUTHOR("Simon Que ");
MODULE_AUTHOR("Hari Kanigeri ");
MODULE_AUTHOR("Ohad Ben-Cohen ");

Messung V0.5
C=90 H=96 G=93

¤ Dauer der Verarbeitung: 0.12 Sekunden  (vorverarbeitet)  ¤

*© Formatika GbR, Deutschland






Wurzel

Suchen

Beweissystem der NASA

Beweissystem Isabelle

NIST Cobol Testsuite

Cephes Mathematical Library

Wiener Entwicklungsmethode

Haftungshinweis

Die Informationen auf dieser Webseite wurden nach bestem Wissen sorgfältig zusammengestellt. Es wird jedoch weder Vollständigkeit, noch Richtigkeit, noch Qualität der bereit gestellten Informationen zugesichert.

Bemerkung:

Die farbliche Syntaxdarstellung und die Messung sind noch experimentell.