/* Disable writes through the rom window */
ret = pci_read_config_word(window->pdev, BIOS_CNTL, &word); if (!ret)
pci_write_config_word(window->pdev, BIOS_CNTL, word & ~1);
pci_dev_put(window->pdev);
/* Free all of the mtd devices */
list_for_each_entry_safe(map, scratch, &window->maps, list) { if (map->rsrc.parent)
release_resource(&map->rsrc);
mtd_device_unregister(map->mtd);
map_destroy(map->mtd);
list_del(&map->list);
kfree(map);
} if (window->rsrc.parent)
release_resource(&window->rsrc); if (window->virt) {
iounmap(window->virt);
window->virt = NULL;
window->phys = 0;
window->size = 0;
window->pdev = NULL;
}
}
/* For now I just handle the ichx and I assume there * are not a lot of resources up at the top of the address * space. It is possible to handle other devices in the * top 16MB but it is very painful. Also since * you can only really attach a FWH to an ICHX there * a number of simplifications you can make. * * Also you can page firmware hubs if an 8MB window isn't enough * but don't currently handle that case either.
*/
window->pdev = pdev;
if (window->phys == 0) {
printk(KERN_ERR MOD_NAME ": Rom window is closed\n"); goto out;
}
window->phys -= 0x400000UL;
window->size = (0xffffffffUL - window->phys) + 1UL;
/* Enable writes through the rom window */
pci_read_config_word(pdev, BIOS_CNTL, &word); if (!(word & 1) && (word & (1<<1))) { /* The BIOS will generate an error if I enable * this device, so don't even try.
*/
printk(KERN_ERR MOD_NAME ": firmware access control, I can't enable writes\n"); goto out;
}
pci_write_config_word(pdev, BIOS_CNTL, word | 1);
/* * Try to reserve the window mem region. If this fails then * it is likely due to the window being "reserved" by the BIOS.
*/
window->rsrc.name = MOD_NAME;
window->rsrc.start = window->phys;
window->rsrc.end = window->phys + window->size - 1;
window->rsrc.flags = IORESOURCE_MEM | IORESOURCE_BUSY; if (request_resource(&iomem_resource, &window->rsrc)) {
window->rsrc.parent = NULL;
printk(KERN_DEBUG MOD_NAME ": " "%s(): Unable to register resource %pR - kernel bug?\n",
__func__, &window->rsrc);
}
/* Map the firmware hub into my address space. */
window->virt = ioremap(window->phys, window->size); if (!window->virt) {
printk(KERN_ERR MOD_NAME ": ioremap(%08lx, %08lx) failed\n",
window->phys, window->size); goto out;
}
/* Get the first address to look for an rom chip at */
map_top = window->phys; if ((window->phys & 0x3fffff) != 0) {
map_top = window->phys + 0x400000;
} #if 1 /* The probe sequence run over the firmware hub lock * registers sets them to 0x7 (no access). * Probe at most the last 4M of the address space.
*/ if (map_top < 0xffc00000) {
map_top = 0xffc00000;
} #endif /* Loop through and look for rom chips */ while((map_top - 1) < 0xffffffffUL) { struct cfi_private *cfi; unsignedlong offset; int i;
if (!map) {
map = kmalloc(sizeof(*map), GFP_KERNEL); if (!map) goto out;
}
memset(map, 0, sizeof(*map));
INIT_LIST_HEAD(&map->list);
map->map.name = map->map_name;
map->map.phys = map_top;
offset = map_top - window->phys;
map->map.virt = (void __iomem *)
(((unsignedlong)(window->virt)) + offset);
map->map.size = 0xffffffffUL - map_top + 1UL; /* Set the name of the map to the address I am trying */
sprintf(map->map_name, "%s @%08Lx",
MOD_NAME, (unsignedlonglong)map->map.phys);
/* Firmware hubs only use vpp when being programmed * in a factory setting. So in-place programming * needs to use a different method.
*/ for(map->map.bankwidth = 32; map->map.bankwidth;
map->map.bankwidth >>= 1)
{ char **probe_type; /* Skip bankwidths that are not supported */ if (!map_bankwidth_supported(map->map.bankwidth)) continue;
/* Setup the map methods */
simple_map_init(&map->map);
/* Try all of the probe methods */
probe_type = rom_probe_types; for(; *probe_type; probe_type++) {
map->mtd = do_map_probe(*probe_type, &map->map); if (map->mtd) goto found;
}
}
map_top += ROM_PROBE_STEP_SIZE; continue;
found: /* Trim the size if we are larger than the map */ if (map->mtd->size > map->map.size) {
printk(KERN_WARNING MOD_NAME " rom(%llu) larger than window(%lu). fixing...\n",
(unsignedlonglong)map->mtd->size, map->map.size);
map->mtd->size = map->map.size;
} if (window->rsrc.parent) { /* * Registering the MTD device in iomem may not be possible * if there is a BIOS "reserved" and BUSY range. If this * fails then continue anyway.
*/
map->rsrc.name = map->map_name;
map->rsrc.start = map->map.phys;
map->rsrc.end = map->map.phys + map->mtd->size - 1;
map->rsrc.flags = IORESOURCE_MEM | IORESOURCE_BUSY; if (request_resource(&window->rsrc, &map->rsrc)) {
printk(KERN_ERR MOD_NAME ": cannot reserve MTD resource\n");
map->rsrc.parent = NULL;
}
}
/* Make the whole region visible in the map */
map->map.virt = window->virt;
map->map.phys = window->phys;
cfi = map->map.fldrv_priv; for(i = 0; i < cfi->numchips; i++) {
cfi->chips[i].start += offset;
}
/* Now that the mtd devices is complete claim and export it */
map->mtd->owner = THIS_MODULE; if (mtd_device_register(map->mtd, NULL, 0)) {
map_destroy(map->mtd);
map->mtd = NULL; goto out;
}
/* Calculate the new value of map_top */
map_top += map->mtd->size;
Die Informationen auf dieser Webseite wurden
nach bestem Wissen sorgfältig zusammengestellt. Es wird jedoch weder Vollständigkeit, noch Richtigkeit,
noch Qualität der bereit gestellten Informationen zugesichert.
Bemerkung:
Die farbliche Syntaxdarstellung und die Messung sind noch experimentell.