// SPDX-License-Identifier: GPL-2.0-or-later /* Unbuffered and direct write support. * * Copyright (C) 2023 Red Hat, Inc. All Rights Reserved. * Written by David Howells (dhowells@redhat.com)
*/
/* * Perform an unbuffered write where we may have to do an RMW operation on an * encrypted file. This can also be used for direct I/O writes.
*/
ssize_t netfs_unbuffered_write_iter_locked(struct kiocb *iocb, struct iov_iter *iter, struct netfs_group *netfs_group)
{ struct netfs_io_request *wreq; unsignedlonglong start = iocb->ki_pos; unsignedlonglong end = start + iov_iter_count(iter);
ssize_t ret, n;
size_t len = iov_iter_count(iter); bool async = !is_sync_kiocb(iocb);
_enter("");
/* We're going to need a bounce buffer if what we transmit is going to * be different in some way to the source buffer, e.g. because it gets * encrypted/compressed or because it needs expanding to a block size.
*/ // TODO
{ /* If this is an async op and we're not using a bounce buffer, * we have to save the source buffer as the iterator is only * good until we return. In such a case, extract an iterator * to represent as much of the the output buffer as we can * manage. Note that the extraction might not be able to * allocate a sufficiently large bvec array and may shorten the * request.
*/ if (user_backed_iter(iter)) {
n = netfs_extract_user_iter(iter, len, &wreq->buffer.iter, 0); if (n < 0) {
ret = n; goto error_put;
}
wreq->direct_bv = (struct bio_vec *)wreq->buffer.iter.bvec;
wreq->direct_bv_count = n;
wreq->direct_bv_unpin = iov_iter_extract_will_pin(iter);
} else { /* If this is a kernel-generated async DIO request, * assume that any resources the iterator points to * (eg. a bio_vec array) will persist till the end of * the op.
*/
wreq->buffer.iter = *iter;
}
}
__set_bit(NETFS_RREQ_USE_IO_ITER, &wreq->flags); if (async)
__set_bit(NETFS_RREQ_OFFLOAD_COLLECTION, &wreq->flags);
/* Copy the data into the bounce buffer and encrypt it. */ // TODO
/* Dispatch the write. */
__set_bit(NETFS_RREQ_UPLOAD_TO_SERVER, &wreq->flags); if (async)
wreq->iocb = iocb;
wreq->len = iov_iter_count(&wreq->buffer.iter);
ret = netfs_unbuffered_write(wreq, is_sync_kiocb(iocb), wreq->len); if (ret < 0) {
_debug("begin = %zd", ret); goto out;
}
if (!async) {
ret = netfs_wait_for_write(wreq); if (ret > 0)
iocb->ki_pos += ret;
} else {
ret = -EIOCBQUEUED;
}
/** * netfs_unbuffered_write_iter - Unbuffered write to a file * @iocb: IO state structure * @from: iov_iter with data to write * * Do an unbuffered write to a file, writing the data directly to the server * and not lodging the data in the pagecache. * * Return: * * Negative error code if no data has been written at all of * vfs_fsync_range() failed for a synchronous write * * Number of bytes written, even for truncated writes
*/
ssize_t netfs_unbuffered_write_iter(struct kiocb *iocb, struct iov_iter *from)
{ struct file *file = iocb->ki_filp; struct address_space *mapping = file->f_mapping; struct inode *inode = mapping->host; struct netfs_inode *ictx = netfs_inode(inode);
ssize_t ret;
loff_t pos = iocb->ki_pos; unsignedlonglong end = pos + iov_iter_count(from) - 1;
ret = netfs_start_io_direct(inode); if (ret < 0) return ret;
ret = generic_write_checks(iocb, from); if (ret <= 0) goto out;
ret = file_remove_privs(file); if (ret < 0) goto out;
ret = file_update_time(file); if (ret < 0) goto out; if (iocb->ki_flags & IOCB_NOWAIT) { /* We could block if there are any pages in the range. */
ret = -EAGAIN; if (filemap_range_has_page(mapping, pos, end)) if (filemap_invalidate_inode(inode, true, pos, end)) goto out;
} else {
ret = filemap_write_and_wait_range(mapping, pos, end); if (ret < 0) goto out;
}
/* * After a write we want buffered reads to be sure to go to disk to get * the new data. We invalidate clean cached page from the region we're * about to write. We do this *before* the write so that we can return * without clobbering -EIOCBQUEUED from ->direct_IO().
*/
ret = filemap_invalidate_inode(inode, true, pos, end); if (ret < 0) goto out;
end = iocb->ki_pos + iov_iter_count(from); if (end > ictx->zero_point)
ictx->zero_point = end;
Die Informationen auf dieser Webseite wurden
nach bestem Wissen sorgfältig zusammengestellt. Es wird jedoch weder Vollständigkeit, noch Richtigkeit,
noch Qualität der bereit gestellten Informationen zugesichert.
Bemerkung:
Die farbliche Syntaxdarstellung und die Messung sind noch experimentell.