// SPDX-License-Identifier: GPL-2.0
/*
* Marvell RD88F6181 Common Board descrition
*
* Andrew Lunn <andrew@lunn.ch>
*
* This file contains the definitions that are common between the two
* variants of the Marvell Kirkwood Development Board.
*/
#include "kirkwood.dtsi"
#include "kirkwood-6281.dtsi"
/ {
memory {
device_type = "memory";
reg = <0x00000000 0x20000000>;
};
chosen {
bootargs = "console=ttyS0,115200n8";
stdout-path = &uart0;
};
ocp@f1000000 {
pinctrl: pin-controller@10000 {
pinctrl-names = "default";
pmx_sdio_cd: pmx-sdio-cd {
marvell,pins = "mpp28";
marvell,function = "gpio";
};
};
serial@12000 {
status = "okay";
};
sata@80000 {
status = "okay";
nr-ports = <2>;
};
mvsdio@90000 {
pinctrl-0 = <&pmx_sdio &pmx_sdio_cd>;
pinctrl-names = "default";
status = "okay";
cd-gpios = <&gpio0 28 GPIO_ACTIVE_HIGH>;
/* No WP GPIO */
};
};
};
&nand {
status = "okay";
partition@0 {
label = "u-boot";
reg = <0x0000000 0x100000>;
read-only;
};
partition@100000 {
label = "uImage";
reg = <0x0100000 0x200000>;
};
partition@300000 {
label = "rootfs";
reg = <0x0300000 0x500000>;
};
};
&mdio {
status = "okay";
switch: switch@0 {
compatible = "marvell,mv88e6085";
#address-cells = <1>;
#size-cells = <0>;
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
label = "lan1";
};
port@1 {
reg = <1>;
label = "lan2";
};
port@2 {
reg = <2>;
label = "lan3";
};
port@3 {
reg = <3>;
label = "lan4";
};
port@5 {
reg = <5>;
phy-mode = "rgmii-id";
ethernet = <ð0port>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
};
};
};
ð0 {
status = "okay";
ethernet0-port@0 {
speed = <1000>;
duplex = <1>;
};
};
&pciec {
status = "okay";
};
&pcie0 {
status = "okay";
};
