// SPDX-License-Identifier: BSD-3-Clause
/*
* Copyright (c) 2020, Konrad Dybcio
*/
#include <dt-bindings/iio/qcom,spmi-vadc.h>
#include <dt-bindings/input/linux-event-codes.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
#include <dt-bindings/thermal/thermal.h>
/ {
thermal-zones {
pm660-thermal {
polling-delay-passive = <250>;
thermal-sensors = <&pm660_temp>;
trips {
pm660_alert0: pm660-alert0 {
temperature = <95000>;
hysteresis = <2000>;
type = "passive";
};
pm660_crit: pm660-crit {
temperature = <125000>;
hysteresis = <2000>;
type = "critical";
};
};
};
};
};
&spmi_bus {
pmic@0 {
compatible = "qcom,pm660", "qcom,spmi-pmic";
reg = <0x0 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
rtc@6000 {
compatible = "qcom,pm8941-rtc";
reg = <0x6000>, <0x6100>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
};
pon: pon@800 {
compatible = "qcom,pm8998-pon";
reg = <0x800>;
mode-bootloader = <0x2>;
mode-recovery = <0x1>;
pon_pwrkey: pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
linux,code = <KEY_POWER>;
status = "disabled";
};
pon_resin: resin {
compatible = "qcom,pm8941-resin";
interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
status = "disabled";
};
};
pm660_charger: charger@1000 {
compatible = "qcom,pm660-charger";
reg = <0x1000>;
interrupts = <0x0 0x13 0x4 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x12 0x2 IRQ_TYPE_EDGE_BOTH>,
<0x0 0x16 0x1 IRQ_TYPE_EDGE_RISING>,
<0x0 0x13 0x6 IRQ_TYPE_EDGE_RISING>;
interrupt-names = "usb-plugin", "bat-ov", "wdog-bark", "usbin-icl-change";
io-channels = <&pm660_rradc 3>,
<&pm660_rradc 4>;
io-channel-names = "usbin_i", "usbin_v";
status = "disabled";
};
pm660_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>;
io-channels = <&pm660_adc ADC5_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pm660_adc: adc@3100 {
compatible = "qcom,spmi-adc-rev2";
reg = <0x3100>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
channel@0 {
reg = <ADC5_REF_GND>;
qcom,decimation = <1024>;
qcom,pre-scaling = <1 1>;
label = "ref_gnd";
};
channel@1 {
reg = <ADC5_1P25VREF>;
qcom,decimation = <1024>;
qcom,pre-scaling = <1 1>;
label = "vref_1p25";
};
channel@6 {
reg = <ADC5_DIE_TEMP>;
qcom,decimation = <1024>;
qcom,pre-scaling = <1 1>;
label = "die_temp";
};
channel@4c {
reg = <ADC5_XO_THERM_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "xo_therm";
};
channel@4d {
reg = <ADC5_AMUX_THM1_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "msm_therm";
};
channel@4e {
reg = <ADC5_AMUX_THM2_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "emmc_therm";
};
channel@4f {
reg = <ADC5_AMUX_THM3_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "pa_therm0";
};
channel@50 {
reg = <ADC5_AMUX_THM4_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "pa_therm1";
};
channel@51 {
reg = <ADC5_AMUX_THM5_100K_PU>;
qcom,pre-scaling = <1 1>;
qcom,decimation = <1024>;
qcom,hw-settle-time = <200>;
qcom,ratiometric;
label = "quiet_therm";
};
channel@83 {
reg = <ADC5_VPH_PWR>;
qcom,decimation = <1024>;
qcom,pre-scaling = <1 3>;
label = "vph_pwr";
};
channel@85 {
reg = <ADC5_VCOIN>;
qcom,decimation = <1024>;
qcom,pre-scaling = <1 3>;
label = "vcoin";
};
};
pm660_rradc: adc@4500 {
compatible = "qcom,pm660-rradc";
reg = <0x4500>;
#io-channel-cells = <1>;
status = "disabled";
};
pm660_gpios: gpio@c000 {
compatible = "qcom,pm660-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pm660_gpios 0 0 13>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
pmic@1 {
compatible = "qcom,pm660", "qcom,spmi-pmic";
reg = <0x1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pm660_spmi_regulators: regulators {
compatible = "qcom,pm660-regulators";
};
};
};
