/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Copyright ( c ) 2007 Intel Corporation . All rights reserved .
*
* Maintained at www . Open - FCoE . org
*/
#ifndef _FC_FCP_H_
#define _FC_FCP_H_
#include <scsi/scsi.h>
/*
* Fibre Channel Protocol for SCSI .
* From T10 FCP - 3 , T10 project 1560 - D Rev 4 , Sept . 13 , 2005 .
*/
/*
* fc / fs . h defines FC_TYPE_FCP .
*/
/*
* Service parameter page parameters ( word 3 bits ) for Process Login .
*/
#define FCP_SPPF_TASK_RETRY_ID 0 x0200 /* task retry ID requested */
#define FCP_SPPF_RETRY 0 x0100 /* retry supported */
#define FCP_SPPF_CONF_COMPL 0 x0080 /* confirmed completion allowed */
#define FCP_SPPF_OVLY_ALLOW 0 x0040 /* data overlay allowed */
#define FCP_SPPF_INIT_FCN 0 x0020 /* initiator function */
#define FCP_SPPF_TARG_FCN 0 x0010 /* target function */
#define FCP_SPPF_RD_XRDY_DIS 0 x0002 /* disable XFER_RDY for reads */
#define FCP_SPPF_WR_XRDY_DIS 0 x0001 /* disable XFER_RDY for writes */
/*
* FCP_CMND IU Payload .
*/
struct fcp_cmnd {
struct scsi_lun fc_lun; /* logical unit number */
__u8 fc_cmdref; /* command reference number */
__u8 fc_pri_ta; /* priority and task attribute */
__u8 fc_tm_flags; /* task management flags */
__u8 fc_flags; /* additional len & flags */
__u8 fc_cdb[16 ]; /* base CDB */
__be32 fc_dl; /* data length (must follow fc_cdb) */
};
#define FCP_CMND_LEN 32 /* expected length of structure */
struct fcp_cmnd32 {
struct scsi_lun fc_lun; /* logical unit number */
__u8 fc_cmdref; /* command reference number */
__u8 fc_pri_ta; /* priority and task attribute */
__u8 fc_tm_flags; /* task management flags */
__u8 fc_flags; /* additional len & flags */
__u8 fc_cdb[32 ]; /* base CDB */
__be32 fc_dl; /* data length (must follow fc_cdb) */
};
#define FCP_CMND32_LEN 48 /* expected length of structure */
#define FCP_CMND32_ADD_LEN (16 / 4 ) /* Additional cdb length */
/*
* fc_pri_ta .
*/
#define FCP_PTA_SIMPLE 0 /* simple task attribute */
#define FCP_PTA_HEADQ 1 /* head of queue task attribute */
#define FCP_PTA_ORDERED 2 /* ordered task attribute */
#define FCP_PTA_ACA 4 /* auto. contingent allegiance */
#define FCP_PTA_MASK 7 /* mask for task attribute field */
#define FCP_PRI_SHIFT 3 /* priority field starts in bit 3 */
#define FCP_PRI_RESVD_MASK 0 x80 /* reserved bits in priority field */
/*
* fc_tm_flags - task management flags field .
*/
#define FCP_TMF_CLR_ACA 0 x40 /* clear ACA condition */
#define FCP_TMF_TGT_RESET 0 x20 /* target reset task management,
deprecated as of FCP-3 */
#define FCP_TMF_LUN_RESET 0 x10 /* logical unit reset task management */
#define FCP_TMF_CLR_TASK_SET 0 x04 /* clear task set */
#define FCP_TMF_ABT_TASK_SET 0 x02 /* abort task set */
/*
* fc_flags .
* Bits 7 : 2 are the additional FCP_CDB length / 4 .
*/
#define FCP_CFL_LEN_MASK 0 xfc /* mask for additional length */
#define FCP_CFL_LEN_SHIFT 2 /* shift bits for additional length */
#define FCP_CFL_RDDATA 0 x02 /* read data */
#define FCP_CFL_WRDATA 0 x01 /* write data */
/*
* FCP_TXRDY IU - transfer ready payload .
*/
struct fcp_txrdy {
__be32 ft_data_ro; /* data relative offset */
__be32 ft_burst_len; /* burst length */
__u8 _ft_resvd[4 ]; /* reserved */
};
#define FCP_TXRDY_LEN 12 /* expected length of structure */
/*
* FCP_RESP IU - response payload .
*
* The response payload comes in three parts : the flags / status , the
* sense / response lengths and the sense data / response info section .
*
* From FCP3r04 , note 6 of section 9 . 5 . 13 :
*
* Some early implementations presented the FCP_RSP IU without the FCP_RESID ,
* FCP_SNS_LEN , and FCP_RSP_LEN fields if the FCP_RESID_UNDER , FCP_RESID_OVER ,
* FCP_SNS_LEN_VALID , and FCP_RSP_LEN_VALID bits were all set to zero . This
* non - standard behavior should be tolerated .
*
* All response frames will always contain the fcp_resp template . Some
* will also include the fcp_resp_len template .
*
* From Table 23 , the FCP_RSP_INFO can either be 4 bytes or 8 bytes , both
* are valid length .
*/
struct fcp_resp {
__u8 _fr_resvd[8 ]; /* reserved */
__be16 fr_retry_delay; /* retry delay timer */
__u8 fr_flags; /* flags */
__u8 fr_status; /* SCSI status code */
};
#define FCP_RESP_LEN 12 /* expected length of structure */
struct fcp_resp_ext {
__be32 fr_resid; /* Residual value */
__be32 fr_sns_len; /* SCSI Sense length */
__be32 fr_rsp_len; /* Response Info length */
/*
* Optionally followed by RSP info and / or SNS info and / or
* bidirectional read residual length , if any .
*/
};
#define FCP_RESP_EXT_LEN 12 /* expected length of the structure */
struct fcp_resp_rsp_info {
__u8 _fr_resvd[3 ]; /* reserved */
__u8 rsp_code; /* Response Info Code */
__u8 _fr_resvd2[4 ]; /* reserved */
};
#define FCP_RESP_RSP_INFO_LEN4 4 /* without reserved field */
#define FCP_RESP_RSP_INFO_LEN8 8 /* with reserved field */
struct fcp_resp_with_ext {
struct fcp_resp resp;
struct fcp_resp_ext ext;
};
#define FCP_RESP_WITH_EXT (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
/*
* fr_flags .
*/
#define FCP_BIDI_RSP 0 x80 /* bidirectional read response */
#define FCP_BIDI_READ_UNDER 0 x40 /* bidir. read less than requested */
#define FCP_BIDI_READ_OVER 0 x20 /* DL insufficient for full transfer */
#define FCP_CONF_REQ 0 x10 /* confirmation requested */
#define FCP_RESID_UNDER 0 x08 /* transfer shorter than expected */
#define FCP_RESID_OVER 0 x04 /* DL insufficient for full transfer */
#define FCP_SNS_LEN_VAL 0 x02 /* SNS_LEN field is valid */
#define FCP_RSP_LEN_VAL 0 x01 /* RSP_LEN field is valid */
/*
* rsp_codes
*/
enum fcp_resp_rsp_codes {
FCP_TMF_CMPL = 0 ,
FCP_DATA_LEN_INVALID = 1 ,
FCP_CMND_FIELDS_INVALID = 2 ,
FCP_DATA_PARAM_MISMATCH = 3 ,
FCP_TMF_REJECTED = 4 ,
FCP_TMF_FAILED = 5 ,
FCP_TMF_INVALID_LUN = 9 ,
};
/*
* FCP SRR Link Service request - Sequence Retransmission Request .
*/
struct fcp_srr {
__u8 srr_op; /* opcode ELS_SRR */
__u8 srr_resvd[3 ]; /* opcode / reserved - must be zero */
__be16 srr_ox_id; /* OX_ID of failed command */
__be16 srr_rx_id; /* RX_ID of failed command */
__be32 srr_rel_off; /* relative offset */
__u8 srr_r_ctl; /* r_ctl for the information unit */
__u8 srr_resvd2[3 ]; /* reserved */
};
/*
* Feature bits in name server FC - 4 Features object .
*/
#define FCP_FEAT_TARG (1 << 0 ) /* target function supported */
#define FCP_FEAT_INIT (1 << 1 ) /* initiator function supported */
#endif /* _FC_FCP_H_ */
Messung V0.5 in Prozent C=96 H=95 G=95
¤ Dauer der Verarbeitung: 0.11 Sekunden
(vorverarbeitet am 2026-10-11)
¤
*© Formatika GbR, Deutschland